Page 1 of 1
Flimsy Buletteer
Posted:
April 10th, 2015, 12:40 pmby TanKoL
Hobby question about those bad boys
Do you have a good trick to make their "arms" and weapons sturdier ?
They're too thin to be pinned, they break all the time ...
Any advice ?
Re: Flimsy Buletteer
Posted:
April 10th, 2015, 12:44 pmby chromedog
No trick. I just pinned mine.
But I also pinned the antennae on the dronbots.
Re: Flimsy Buletteer
Posted:
April 10th, 2015, 1:59 pmby TanKoL
I guess I need a smaller drill then
Re: Flimsy Buletteer
Posted:
April 11th, 2015, 6:51 amby chromedog
I have a selection of bits from 0.3mm up to 1.2mm for the pin vice.
Anything bigger gets the cordless drill.
You have to take your time with the small ones and not push too hard - they are ever so easy to snap.