by Section9 » March 8th, 2014, 7:52 pm
by Splod » March 8th, 2014, 11:16 pm
by Mob of Blondes » March 9th, 2014, 1:57 am
by VisOne » March 9th, 2014, 2:09 am
by Antenociti » March 9th, 2014, 2:10 am
Mob of Blondes wrote: I wonder why.
by Antenociti » March 9th, 2014, 2:11 am
by Splod » March 9th, 2014, 5:17 am
by chromedog » March 9th, 2014, 11:57 am
by Splod » March 9th, 2014, 12:55 pm
by Section9 » March 9th, 2014, 7:58 pm
by WookieeGunner » March 10th, 2014, 1:04 am
by Section9 » March 10th, 2014, 5:16 am
WookieeGunner wrote:The biggest problem is a legal one. Most of the companies are too small to justify the expense of lawyers familiar enough with International trade laws to handle the contracts.
by Splod » March 10th, 2014, 7:04 am
by Antenociti » March 10th, 2014, 9:02 pm
Section9 wrote:That's the idea.
get the official license(s) from [insert non-US company here] to not get eaten alive by the shipping charges.
The real kicker at the licensee end would be MDF quality and thickness. If I can't get say, 2.5mm +-.1mm MDF, then designs would have to be altered to get stuff to fit with the thickness that I can get, which would be a near-redesign of the entire product (as I understand the laser-cutting setup).
by Section9 » March 11th, 2014, 6:31 am
by kidterminal » March 14th, 2014, 3:30 am
by Section9 » March 15th, 2014, 1:49 am
kidterminal wrote:The best bet would seem to be a limited partnership between an American company and say a European or Australasian company. By that I mean two established companies in different continents enter into an agreement to produce each others designs on "their" continent.
by kidterminal » March 15th, 2014, 2:43 am